- Home /
- Toroidal core mounting plate, vertical, 4 pins
Mounting plate for toroidal cores
For toroidal cores with a diameter of ca. 45 mm (wounded) and 16 mm width (wounded).
Dimensions:
Length: 26,5 mm
Width: 19 mm (without contacts)
Height: maximum 6 mm
The pins are arranged in block of 39,48 mm x 12,7 mm and has a diameter of 0,8 mm.
The plate has a slot for a tie wrap on the bottom side. So that you can affix the toroidal core by an tie wrap.
We can calculate and wind your toroidal cores on demand. Furthermore we can mount them onto this plate. Please, ask for a quotation!
Packing unit: 1 piece
Click on the picture to enlarge.
For toroidal cores with a diameter of ca. 45 mm (wounded) and 16 mm width (wounded).
Dimensions:
Length: 26,5 mm
Width: 19 mm (without contacts)
Height: maximum 6 mm
The pins are arranged in block of 39,48 mm x 12,7 mm and has a diameter of 0,8 mm.
The plate has a slot for a tie wrap on the bottom side. So that you can affix the toroidal core by an tie wrap.
We can calculate and wind your toroidal cores on demand. Furthermore we can mount them onto this plate. Please, ask for a quotation!
Packing unit: 1 piece
Click on the picture to enlarge.
Category Navigation:
- Enamelled & Litz Copper Wires
- Bottles and Tins
- Chokes & transformer & filter
- Ferrite- & Iron powder Cores
- Boxes and mounting plates
- Insulating materials
- Soldering and Flux
- Magnets
- RFID Transponder coil
- Coil formers and equipment
- Pot core sensor coil
- Impregnating varnish